mW65

charter

Principal Data

Length Overall 19.90 metres Length WL 17.40 metres Beam 5.20 metres Draft 2.35 metres Displacement 25000kg Ballast 9000kg Construction  Aluminium Main Engines 110 kW Auxiliary  15kVa Propeller 20" feathering Fuel Capacity 1000 litres Freshwater 2500 litres Grey/Black Water 750 litres Berths 4 x 2 Guests, 3 Crew 5 x 2 Guests, 2 Crew Mainsail 94.4 m2 Genoa 79.0 m2 I 22.0 m P 19.6 m J 7.2 m E 8.2 m

download ga.pdf (339kB)

Lower Deck Options

Profile, Plan and End Elevation

Vessel Description

SURVEY AND CLASSIFICATION:

Shall comply with the requirements of Queensland Survey USL 2B

Hull and deck structure to Class

CONSTRUCTION:

HULL AND DECK: Sheet and Plate - Grade 5083-H321, H116, 5086-H32, Extrusions - Grade 6061-T6, 6082-T5

Filler Wire - Grade 5356, Castings - Grade CC601-T1. All welders to be approved by the Survey Authority.

Shoal Keel with lead bulb. Balanced rudder. SS striker plate.

DECK EQUIPMENT:

Muir VRC3500A Anchor windlass, Gebo hatchs, flush hatchs to anchor locker, lazarette and lifting BBQ. Flexiteek decking. SS pushpit , pullpit, staunchions and lifelines. Sheer rail. Anchors; 70kg Plough, 40kg Danforth.

Hydraulic stern door / swim platform.

Aft cockpit: Twin steering. 40" SS 3 spoke wheel, 2 x pedestal with compass and sailing instruments.

Centre cockpit: Folding table, remote helm, front opening esky, optional dodger and bimini.

RIG AND SAIL HANDLING:

Custom spars, keel stepped, sloop rigged, with white paint finish

Mainsail; Crosscut construction in two ply Dacron, Four full length battens, two rows of reefing points. Lazy boom cover.
Furling Genoa and Furling Staysail with crosscut construction in Dacron.
4 x Arco 66ST 2 speed 24V Electric winch. 1 x Arco 60ST 2 speed 24V Electric halyard winch.

Manual furlers, Arco 4800, 3200 for genoa and staysail.
Navtec hydraulic boom vang with remote control panel. 2 off manual backstay tensioners.

Ronstan/Frederiksen travellers, blocks, clutchs, tracks

OUTFIT AND FINISHING: The vessel shall be laid out as per the general arrangement drawings and all fittings and equipment required for the operation of the vessel shall be supplied.

Fitout: plywood with teak veneer joinery, moulded bench tops galley and heads. 

Galley:  240V Electric cooker, 4 Burners, grill and oven. Exhaust vent above stove. Combination microwave and convection oven. Garbage compactor. 240V Eutectic Fridge Freezer (470lts). Double sink with hot and cold water.

Heads: 5 off, Electric toilets, sink and shower with hot and cold water, shower curtain, vanity cabinet. Exhaust vent.

Wet locker under stairs with vent and drain. Hot and cold shower at lazarette.

AIR CONDITIONING SYSTEM: System is based on an water cooled compressor unit linked up to a multiple number of fan coil units. Design of the system shall be based upon an ambient operating temperature of 35°C (90% RH) and sea water of 32°C. Crew and Passenger  spaces to be cooled to 21°C (50% RH).

NAVIGATION and COMMUNICATION EQUIPMENT:

(as per survey requirements of USL 2B)
RADAR: JRC JMA-2254 10" Rasterscan Radar 4 kW output, 48NM range, 3.5" antenna, twin EBL's and VRM's 24v DC
GPS / ECHO SOUNDER: RC JFV-850 10" Colour Sounder, 200 / 50khz dual frequency 600W output, shallow and deep alarms, zoom, inbuilt track plotter 24v DC
LOG: Silva Sea Data
VHF RADIO: GME GX548
HF SSB RADIO: Barrett 550 HF SSB Transceiver
AUTOPILOT: Navicontrol AP3003, 24v DC
COMPASS: Cetrek "Poseidon"
SEARCHLIGHT: Den Haan DHR CS-220

SAILING INSTRUMENTS: B&G HYDRA H1000 SYSTEM

48 Sweetgum St, Ashmore Qld 4214, Australia, Ph: (617) 5597 3521 Fax: (617) 5597 3529

E-Mail: info@mwdesign.net.au